Fleet-engineers INS-07040 User Manual download pdf

Installation Sheet #INS-07040 • 1/08

NOTE: These instructions for installation are intended to be a

general guide to help the installer. The installer is responsible for

the ultimate installation design. Any modiﬁcations to the product

are at the discretion, responsibility and risk of the installer.

1. Clean top fender channel of dirt and grime.

2. Place the Decorative Stainless Steel Insert in the fender

channel with the

protective plastic PVC

side facing up. Mark

both holes of the insert

on to the plastic fender.

3. Remove the Decorative

Stainless Steel Insert

from the channel and

drill a 3/8” hole on each

mark that was made.

Spray Mate/Spray Master

Decorative Stainless Steel Insert

Installation Instructions

Installation Sheet #INS-07040

4. Place a continuous 1/8”

bead of adhesive in a

zig-zag pattern down

the center of the fender

channel.

5. Place the Decorative

Stainless Steel Insert

into the channel with the

protective plastic PVC

side up.

6. Install a carriage bolt into

each hole of the insert,

place a washer and nut

onto the back side of

each bolt and tighten. Do

not over tighten the bolt

as this will damage the

fender and Decorative

Stainless Steel Inserts.

7. Repeat the procedure

for each of the remaining

Decorative Stainless Steel Inserts.

8. Remove protective plastic PVC from Decorative Stainless

Steel Inserts.

Summary of Contents

Page 1 - Installation Instructions

Installation Sheet #INS-07040 • 1/08NOTE: These instructions for installation are intended to be a general guide to help the installer. The installer

Comments to this Manuals

No comments

Fleet-engineers INS-07040 User Manual

Browse online or download User Manual for Hardware Fleet-engineers INS-07040. Fleet Engineers INS-07040 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Fleet-engineers INS-07040